1. Installation of a single-hole basin faucet when purchasing a single-handle basin faucet, you should pay attention to the diameter of the water outlet. Now most of the water in the market belongs to the hard pipe, so you should pay attention to the height of the water inlet. From the basin down, 35 work points is the most Suitable. When installing, a special angle valve must be selected, and the angle valve must be fixed with the hot and cold water pipes of the wall. When you find that there is a distance between the angle valve and the water pipe on the faucet, buy a special extension pipe to connect it. Remember, you must not use other water pipes to connect, because if the water pressure is high, it is easy to fall off, leak water, and cause losses to you. If the water inlet pipe is too long and exceeds the water outlet pipe, you can cut off the part according to your needs. If the angle is not suitable, you can moderately bend it to the position you need. IMPORTANT: Do not bend hard to 90 degrees or more. When installing the basin to drain, please don't forget to buy the small interface of the faucet (the faucet is shorted). Don't forget to flush the water pipes buried in the wall before you install.

2. Installation of the thermostatic faucet Before installing the thermostatic faucet, please check whether the water pipe is hot on the left and cold on the right. Remember not to connect the hot and cold water pipes wrongly, so as to avoid the faucet not working properly. Gas and solar water heaters cannot use thermostatic faucets because the water pressure is too low. Please do not forget to install the hot and cold water filter when installing the thermostatic faucet.

3. Installation of shower, bathtub faucet (wall-mounted) When you buy shower, bathtub, wall-mounted faucet, you can choose the appropriate height to bury the water pipe. The distance between the hot and cold water pipes must reach 15 cm. Before installation, you must not forget to flush the water pipe, so as not to cause damage to the faucet due to excessive water quality. Concealed shower and bathtub faucets: After purchasing a concealed faucet, the valve core of the faucet should generally be pre-buried in the wall. Be sure to pay attention to the thickness of the bathroom wall before pre-embedding. If the wall is too thin, the valve core will not be able to be embedded. Do not easily remove the plastic protective cover of the valve core during pre-embedding, so as to avoid cement and other miscellaneous damage to the valve core during pre-embedding. In addition, when pre-embedding the valve core, you should also pay attention to the up and down, left and right directions of the valve core, so as to avoid the wrong valve core. Wall-mounted faucet If the size of the pre-buried water inlet pipe is deviated, the adjustable crutch can be used to calibrate the position.

Choose D&S Faucets and we will give you the best service.