How to install faucet hoses？
November 09 , 2021
In winter, everyone wants to use warm hot water as soon as they go home, so many families install hot and cold water faucets so that they can use hot and cold water anytime, then they will not worrying about the cold water trouble them anymore. The most important thing to install the hot and cold water faucet is the hose installation problem, so how to install the hot and cold water faucet hose? Please check the following detailed introductions.
How to install the hot and cold water faucet hose?
1. Close the main water valve first.
2. Locate the problematic hose connector on the water inlet pipe and unscrew it.
3. Then remove the faucet. The faucet is usually fixed on the sink or basin with screws. Find the fixed nut and press it to OK. Then you can unscrew the other end of the broken hose very loosely.
4. Screw on the small end of the new hose without wrapping the sealing tape.
5. Install the faucet in the reverse order of when it was removed. Put the panel and so on back into place.
6. Screw the nut end of the new hose to the water inlet pipe without wrapping the sealing tape. Secure with pliers. All are OK.
The installation of hot and cold water faucet hoses follows the principles.
1. For the installation of hot and cold water pipes in the bathroom, the water pipes are generally on top and not on the ground, and the pipes should be laid horizontally and straight to avoid bending. The layout direction should be safe and reasonable, as far away as possible from the circuit.
2. The hot and cold water pipes in the bathroom should be separated and not too close. The outlets for cold and hot water must be kept level, generally left hot and right cool; the height of the shower hose is between 1.8M-2.1M.
3. The position of the pipe clamp and the slope of the pipe should meet the requirements of the specification. All kinds of valves should be installed in the correct position and installed smoothly, which is easy to use and maintain.
4. The cold and hot water pipes are generally used to enter the wall. When slotting, the depth of the slot should be carefully checked. At the same time, the cold and hot water pipes cannot be in the same slot.
5. When installing the water inlet and outlet of the water heater, the position of the water inlet valve and the air inlet valve must be considered and should be installed in the corresponding position.
I hope you can install the hot and cold water faucet hose in the correct way, so that you can avoid a lot unnecessary trouble.
If you have interest in faucet hoses please kindly contact with D&S Faucets Company,we will provide the best quality and good service for you.
